BCD mode - Activates BCD Mode und interprets the value at the offset a little bit different.The value allows you to explicitly mask certain bits of a value.Įxample: "Lights"-Offset 0x0D0C - hier the various bits represent the states of different lights of an aircraft.Īn example are the "Landing Lights" which are contained as preset. Mask value with - The default value that is set, when you change the byte size normally is the correct one.More Options - Additional settings that are required for some FSUIPC offsets.Offset, Value Typeand Byte Size of an Offset are all provided in the FSUIPC documentation that come with your FSUIPC installation. Base settings - FSUIPC Basis-Einstellungen.Have a look at the Tutorials Section for a more practical example. Confirm the selection by clicking on the "use"-Button - you will see that all values are set automatically.Selecting the desired function from the drop down list, you can type the beginning of an item to reduce the number of items in the list.It is the easiest way to use FSUIPC Offsets. Load preset - Use preset - You can use predefined Settings that come with the MobiFlight Connector.You provide all FSUIPC relevant information on the FSUIPC-Tab: Should they stop to move it is likely that an error occured and the "Run mode" stopped or the application has to be restarted (latter case happens only very rarely). Hint: As long as the little dots move around, the application is running fine. Values are read from and written to FSUIPC, output and input devices are also updated. "Running." - Currently MobiFlight Connector is in "Run-Mode".While not running, the FSUIPC values will and attached devices will not be updated. You stopped it or an have not yet started it.
#FSUIPC KEY ON OFF SOFTWARE#
#FSUIPC KEY ON OFF PC#
#FSUIPC KEY ON OFF SERIAL NUMBER#
Module Serial - The serial number or the name of the used module.It helps for orientation and can be helpful for sorting the rows. FSUIPC Offset - It shows the used FSUIPC offset.Double click on the field in the desired row to activate edit mode. Description - You can assign a meaningful name for each config item.Also during Test Mode only the active items are considered. Only active items are updated with FSUIPC values when running the software. Active - the config item is activated.The config list items contain the following information: The configuration list on the output tab shows you all entries of the currently loaded file (see file name in title bar). Hint: If there are still unsaved changes, you will see a message that informs you and gives you the possibility to first save your changes or discard them - as you like. This makes it easy to be started by FSUIPC on automatically during start up of your flight sim. The order of start (MFConnector and flight sim) does not matter. The application minimizes to the taskbar and it waits until the connection to your flight sim becomes available. AutoRun - Can be activated and then runs MF Connector automatically on next start using the last loaded Configuration (Run-Mode).Stop - Stops the currently active mode (Run/Test).It helps most with LEDs and 7 segment displays With this function you can check that your configuration is addressing the correct output device.
For each configuration item the test mode is toggled. It is only clickable if supported modules are recognized (MobiFlight Board or Arcaze) and your flight sim is running Run - executes the current configuration.It is enabled if there are changes made to the current configuration. Save - save the current configuration.